24/7 support, every day of the week 02192039 info@mizbandade.com
لینوکس

How to Disable IPv6 on CentOS 8

غیرفعال کردن IPv6

Disabling IPv6

Internet Protocol version 6 (IPv6) is the addressing scheme used by network interfaces on an IPv6 network. If you don’t want to use IPv6, you can disable it temporarily or permanently. In this article you’ll learn two ways to disable IPv6 on a CentOS 8 Linux machine.

First, check whether IPv6 is enabled on your CentOS 8 machine with the ip command:

ip a | grep inet6

If IPv6 is enabled, you’ll see some inet6 lines. If the command prints nothing, IPv6 is already disabled on all your network interfaces.

Disable IPv6 with sysctl

This method disables IPv6 without a reboot. However, as you’ll see, it takes a bit more work than the permanent method.

First, create a new sysctl configuration file, /etc/sysctl.d/70-ipv6.conf:

vi /etc/sysctl.d/70-ipv6.conf

Add the following lines and save the file:

net.ipv6.conf.all.disable_ipv6 = 1
net.ipv6.conf.default.disable_ipv6 = 1

Now apply it to disable IPv6:

sysctl --load /etc/sysctl.d/70-ipv6.conf

IPv6 should now be disabled. To check, run the ip command again:

ip a | grep inet6

If it prints nothing, IPv6 is disabled on all your network interfaces.

With this method, some network interfaces may still use IPv6 after a reboot. That’s because CentOS 8 uses NetworkManager by default.

To stop an interface from using IPv6 completely, use nmcli:

nmcli connection modify interface ipv6.method ignore

Finally, reboot your CentOS 8 machine:

reboot

Disable IPv6 with a kernel boot option

This method needs a reboot after configuration, but it’s the best way to disable IPv6.

Open the default GRUB configuration, /etc/default/grub, in vi:

vi /etc/default/grub

Go to the end of the file, press O to open a new line and add:

GRUB_CMDLINE_LINUX="$GRUB_CMDLINE_LINUX ipv6.disable=1"

Save the file and exit.

Next, update the GRUB CFG files. To find them, run:

ls -lh /etc/grub*.cfg

You’ll see two GRUB CFG paths: /boot/grub2/grub.cfg and /boot/efi/EFI/centos/grub.cfg.

Generate a new GRUB configuration and save it to /boot/grub2/grub.cfg:

grub2-mkconfig -o /boot/grub2/grub.cfg

Then generate it again for /boot/efi/EFI/centos/grub.cfg:

grub2-mkconfig -o /boot/efi/EFI/centos/grub.cfg

Finally, reboot your CentOS 8 machine:

reboot

After the reboot, check whether IPv6 is disabled:

ip a | grep inet6

If the command prints nothing, IPv6 is disabled.

Conclusion

You’ve learned two ways to disable IPv6 on CentOS 8 Linux: with sysctl and with a kernel boot option. Disabling IPv6 with sysctl is temporary, while the kernel boot option is permanent and the better method.

We hope you found this article useful. Follow Mizbandade for more.

Leave a comment

Your email address will not be published. Required fields are marked *